Skip to content

Outdated documentation

You are reading outdated documentation. This page documents ChirpStack v3. ChirpStack v4 is the latest version.

RX parameter (re)configuration

ChirpStack Network Server supports the (re)configuration of the following RX parameters:

  • RX delay the delay between the end of TX and the first reception slot.
  • RX1 data-rate offset the offset used to calculate the RX1 data-rate, based on the uplink data-rate.
  • RX2 data-rate the data-rate used for the RX2 receive-window.
  • RX2 frequency the frequency used for the RX2 receive-window.

The first three parameters are sent to the device as part of the OTAA join-accept frame. The RX2 frequency parameter is pushed to the device using the RXParamSetupReq mac-command.

Note: on a ChirpStack Network Server configuration change, the new parameters will be pushed to the device using the RXParamSetupReq or RXTimingSetupReq mac-commands at the first opportunity.